4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 3-11
Connecting the IP TS Output
The Ethernet Interface
The RJ-45 interface IP TS OUT is 10/100/1000BaseT Ethernet. It is intended for
output of the transport stream encapsulated in IP packets to a groomer (e.g., Digital
Content Manager 9900) for distribution.
Informative Notes
For reliable Ethernet operation; to run over a maximum segment length of 100 m
the cable has to comply with the EIA/TIA Category 5E wire specifications.
To Connect the Ethernet Interface
1. Connect a crossed RJ-45 cable between the Ethernet connector on the D9858
transcoder and the Ethernet port of the equipment after the D9858 transcoder.
The equipment after the D9858 Transcoder could be an IP router or a switch.
To Next Page
Loading...
Need help?
General