Cisco PowerVu D9858 - Setup Menu: TS Input: Input: ASI

4-28 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Setup Menu: TS Input: Input: ASI
INPUT
ASI
ASI Active
Description: Sets the input to be active or inactive.
Parameters: ACT or No.
Tune Mode
Description: Sets the mode used to build channel lists from allowed service lists.
Parameters: Auto, Basic, Fixed Pid or Custom. The default is Basic.
CA Ctl
Description: Sets the type of CA (Conditional Access) to determine which
programs can be viewed via the transcoder.
Parameters: STD (standard) for PowerVu signal or Open conditional access for
free-to-air (i.e., in-the-clear signals).
Select
Description: This sets the parameters the transcoder uses for signal switching.
Parameters: RF Map or Preset. RF Map uses the orbital positioning settings to
find and lock onto a signal, while it can be ignored for Preset.
RF1, RF2, RF3, RF4
RF1 Active (RF2, RF3, RF4)
Description: Sets the input to be active or inactive.
Note: Setting a new input to be Active will deactivate the currently
Active input.
Parameters: ACT or No.
Tune Mode
Description: Sets the mode used to build channel lists from allowed service lists.
Parameters: Auto, Basic, Fixed Pid or Custom. The default is Basic.
CA Ctl
Description: Sets the type of CA (Conditional Access) to will determine which
programs can be viewed via the transcoder.
Parameters: STD (standard) for PowerVu signal or Open conditional access for
free-to-air (i.e., in-the-clear signals).
Select
Description: This sets the parameters the transcoder uses for signal switching.
Parameters: RF Map or Preset. RF Map uses the orbital positioning settings to
find and lock onto a signal, while it can be ignored for Preset.