E-2 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Applicable Standards and Notices, Continued
equipment off and on), the user is encouraged to try to correct the interference by
one or more of the following measures:
1. Reorient or relocate the television receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Connect the equipment to an AC outlet on a circuit different from that to which
the receiver is connected.
4. Contact your dealer/ reseller or an experienced radio/ TV technician for help.
The user may find the booklet “Interference handbook” prepared by the Federal
Communications Commission helpful. This booklet is available from the U.S.
Government Printing Office, Washington, DC 20402, stock no. 004-000-00450-7.
Shielded cables should be used to interconnect this device with any other/
peripheral equipment (i.e., data sources, terminals, monitors, etc.) to ensure
compliance with Class B limits. Failure to do so may result in radio or TV
interference. Cables should be of braided shield construction with metal end shells.
Industry Canada Notice
This digital apparatus does not exceed the limits for Class B radio noise emissions
from digital apparatus as set out in the radio interference regulations of the
Industry Canada.
Le present appareil numerique n’emet pas de bruites radioelectriques qui dépassant
les limites applicables aux appareils numeriques de Class B prescrites dans le
reglement sur le brouillage radioelectrique edicte par Industrie Canada.
Unauthorized Modifications
The manufacturer is not responsible for any radio or TV interference resulting from
unauthorized modifications made to this equipment. It is the responsibility of the
user to correct such interference at his own expense.
To Next Page
Loading...
Need help?
General