4-38 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Setup Menu: Services: Video
Stream
Description: This is the format of the incoming stream. It is determined by the
the SD Format setting and the actual format of the incoming stream.
This value is read-only.
SD Format
Description: Selects the video format for the output when the input video is SD
format.
Parameters: Auto, NTSC, PAL-N (AR), PAL-M or PAL-B/G/I/D. Use NTSC for
525-line systems and PAL-B/G/I/D for 625-line systems.
SD Output
Description: Indicates the SD Output video signal format.
Parameters: NTSC, PAL-N (AR), PAL-M or PAL-B/G/I/D.
Bitrate
Description: Indicates the video output bit rate.
Parameters: 1.0 to 15.0 Mbps.
TV A/R
Description: This is the aspect ratio of your TV.
Parameters: 4:3 or 16:9 (wide aspect ratio). The default is 4:3. Set it to the
corresponding value.
Convert
Description: This is the conversion that the transcoder will perform on the
incoming signal for the picture to be displayed correctly (i.e., to
correspond to the aspect ratio of your TV) on your TV, based on
your selection.
Parameters: Auto, None, 16:9 F/W (full width), 4:3 F/H (full height), 14:9, 4:3 P/
B (pillar box), 4:3 L/B (letter box) or Auto AFD (Auto setting using
Active Format Descriptor). The default is set to Auto.
Stream
Description: This indicates the aspect ratio of the incoming signal. This is read-
only.
Act Conv
Description: This is the type of (aspect ratio) conversion the transcoder will
perform based on what you have selected. This is read-only.
To Next Page
Loading...
Need help?
General