4-42 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Setup Menu: Services: Audio
AUDIO
Aud#
Description: This is the audio output number to which all settings on the two
audio menus will apply.
Parameters: Aud1 or Aud2. When you change this option on one of the Audio
Menus, it changes on the other as well. The two audio (Aud#)
menus allow you to configure the two balanced audio outputs on
the rear panel (Audio 1 and Audio 2), known in the transcoder as
Aud1 and Aud2, respectively.
Stereo/Mono
Description: This setting configures how audio received on the audio input is
handled.
Parameters: Stereo (Left and Right are passed directly through to the Left and
Right), R-MONO (Right is passed to both the Left and Right), L-
MONO (Left is passed to both the Left and Right), Mixed (Left is
passed to both the Left and Right, and Right is passed to both the
Left and Right).
AC3 Compression
Description: This is only applicable if the received signal is Dolby Digital (AC-3).
This specifies the AC-3 Compression range of the received audio.
Parameters: Line Mode, Custom 1, Custom 0 or RF Mode. RF Mode is
recommended for analog cable modulators.
Left(dB)
Description: This is the volume adjustment for the Left audio channel.
Parameters: -6.0 dB to +6.0 dB. Any value can be entered with the numeric
keypad (in the appropriate range), but the UP and DOWN arrows
will make increments/decrements at 0.5 dB steps.
Right(dB)
Description: This is the volume adjustment for the Right audio channel.
Parameters: -6.0 dB to +6.0 dB. Any value can be entered with the numeric
keypad (in the appropriate range), but the UP and DOWN arrows
will make increments/decrements at 0.5 dB steps.
PMT Source
Description: Selects the PMT source for the audio channel.
Parameters: None, AUDI, AUD2, AUD3 or AUD4.
To Next Page
Loading...
Need help?
General