4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4-61
Setup Menu: Outputs: TS Out: DPM Continued
Parameters: Drop or Pass. Default is Drop.
PSI Options
Description: This option allows the operator to specify which PSI tables to
include in the program/output stream.
Parameters: Pass All, Drop All or Control by Table.
PSI Rate
Description: This selects the DPM regeneration rate. This applies the PowerVu
rates (consistent with the uplink).
Parameters: Auto, MPEG Min or SA Std.
Output Unref
ASI Pass, Drop
MOIP1 Pass, Drop
PSI Options Description
Pass All Transmits the incoming PSI Tables as is;
does not modify the content and rate.
Drop All Does not transmit any PSI Tables.
Control by Table The operator can enter the Tables menu to
select the output mode for each table. The
default table selections will be all pass, and
only with CDT dropped.
PSI Rate Description
Auto Matches the generated PSI tables' output
rate as the incoming rate.
MPEG Min Transmits the generated PSI tables on the
longest intervals that are allowed by the
MPEG standard.
SA Std Transmits the generated PSI tables based on
PowerVu standard intervals.
To Next Page
Loading...
Need help?
General