4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4-63
Setup Menu: Outputs: TS Out: DPM, Continued
Service ID
Description: This parameter specifies whether the transcoder should always
generate PSI tables for the mapped PE even if the selected input
channel is not available (e.g., Zombie channel), or for only valid
service channels/IDs.
Parameters: Valid Ch or All Ch.
Setting Mode Options Description Default
EMM Pass, Drop Entitlement Management
Message
Pass
DRT Pass, Drop Disaster Recovery Table Pass
CDT Pass, Drop Code Download Table Pass
Svc ID Description
Valid Ch Only transmits the PSI tables for the
mapped program if the program exists in
the input stream.
All Ch Transmits the PSI tables for the mapped
program even if the program does not exist
in the input stream.
All Ch is only valid if the PAT, NIT, SDT
and PMT are set to Regenerate.
To Next Page
Loading...
Need help?
General