4-76 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Setup Menu: Alarm/Warning, Continued
Rly - Yes or No. When set to Yes, the rear panel alarm relay will be
triggered to enable external equipment connected to the alarm port.
Trp - Yes or No. When set to Yes, the SNMP trap message will be
sent to the trap destination; otherwise the fault message will be
ignored.
“No*” indicates the trap or relay is enabled, but Enable is set to No,
which will prevent relay or trap operation.
System Warning Name
Description: Displays a list of the warning messages. You can scroll through the
list using the UP and DOWN arrow keys.
Parameters: Enable - Yes or No. When set to Yes, the warning message will be
reported. When set to No, the fault won’t be reported.
Note: Enable must be set to Yes for Relay and Trap messages
reporting to be functional.
Rly - Yes or No. When set to Yes, the rear panel alarm relay will be
triggered to enable external equipment connected to the alarm port.
Trp - Yes or No. When set to Yes, the SNMP trap message will be
sent to the trap destination; otherwise the warning message will be
ignored.
“No” indicates the trap or relay is enabled, but Enable is set to No,
which will prevent relay or trap operation.
To Next Page
Loading...