Cisco PowerVu D9858 User Manual

4023074 Rev B Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 5-17
Memory Usage Set Excessive (stack/
partition) memory
usage
Cause: Possible software
issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
SW exceeding
allowable memory
usage.
Clear Normal (stack/
partition) memory
usage
Memory Usage Set Excessive (stack/
partition) memory
usage
Cause: Possible software
issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
SW exceeding
allowable memory
usage.
Clear Normal (stack/
partition) memory
usage
FPGA Code Version Set FPGA code version
mismatch:
format(Rel.Maj.Min.
Nan),
Required=#.#.#.#,
Running=#.#.#.#
Cause: Possible HW Issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
FPGA binary identity
does not match FPGA
registers.
Clear FPGA code ver OK
Ethernet PHY # Created fault but not
used.
Cause: No ethernet cable
connected, faulty cabling,
multiple devices sharing
MAC address on same IP
segment, or possible HW
issue.
Remedy: Check cabling,
check MAC addresses,
clear warnings, reset unit,
and notify customer service
if problem persists.
Ethernet MAC PHY
device is attempting
to reconnect to
external devices.
FW: Resource Use
HOST
Set Memory or List Near
Full
Cause: Possible software
issue.
Remedy: Clear warnings,
reset unit, and notify
customer service if problem
persists.
SW exceeding
allowable usage of
internal constructs.
Clear Normal Level
Warning Message
Type
Message Cause/Remedy Description

Cisco PowerVu D9858 Specifications

General

Brand	Cisco
Model	PowerVu D9858
Category	Transcoder
Language	English