3-4 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Installing the D9858 Advanced Receiver Transcoder, Continued
To Connect AC Power
To connect AC power to the D9858 Advanced Receiver Transcoder do the
following:
1. Connect the power cord (supplied with the D9858 Advanced Receiver
Transcoder) between the rear panel power receptacle and a 100 to 120/200 to
240 V AC power outlet.
2. Make sure that the power cable is connected to protective ground.
See Grounding, page 3-3 for more information.
The D9858 transcoder is equipped with one power suppy located in the rear of the
chassis. Note the location of the power supply in the event of alarms/warnings
resulting in replacement of a power supply. Alarm messages appear in the Message
Log.
To Next Page
Loading...
Need help?
General