4-30 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide 4023074 Rev B
Setup Menu: TS Input: Input, RF1-RF4, Continued
E/W
Description: Denotes the satellite position the dish connected to the current RF
Input should point. This is used when the satellite is not available in
the look-up menu list.
Parameters: E, W or NA.
Pol
Description: Marks the polarity of the signal connected to this RF input.
Parameters: H (horizontal), Vert (vertical), A (Auto). Auto is only applicable for
This setting is only applicable when LNB Power is set to H-NIT or
V-NIT.
Validate Orbital Position
Description: This option allows you to configure and validate the RF inputs to
match those expected by the network. The transcoder will check to
see if all the frequencies in the Network Information Table (NIT)
can be tuned to.
Parameters: Yes or No.
Orbital Position Validation Date
Description: This displays the last date that the ‘Validate Orbital Position’
operation was performed.
Parameters: N/A.
Freq
Description: This is the current Downlink operating frequency used by the
transcoder for tuning the received digital signal.
Parameters: 0.0 to 15.0 GHz.
SymRate
Description: This is the symbol rate. The symbol rate must match that of
transmitted signal.
Parameters: 1.0 to 45.0 Ms/s.
FEC
Description: This is the Frequency Error Correction rate. The FEC must match
the FEC of the transmitted signal.
Parameters: 1/2, 2/3, 3/4, 5/6, 7/8 or Auto.
L-Band
Description: This is the L-Band operating frequency used by the transcoder. This
value is determined by the values set in the Freq and LO options.
Parameters: 950 to 2150 MHz.
To Next Page
Loading...
Need help?
General