Cisco TelePresence SX10 - Xcommand Camera Triggerautofocus; Conference Commands; Xcommand Conference Donotdisturb Activate; Xcommand Conference Donotdisturb Deactivate

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 100
Cisco TelePresence SX10
API Reference Guide
xCommand Camera TriggerAutofocus
Trigger the auto-focus functionality. The camera must support auto-focus functionality. If the
camera is daisy chained, the CameraId is given by its place in the chain.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera TriggerAutofocus CameraId: CameraId
where
CameraId : Integer (1..1)
Select the camera to auto-focus.
Conference commands
xCommand Conference DoNotDisturb Activate
This command switches on the Do Not Disturb mode, and the Timeout parameter allows you to
control when it is switched off again. When Do Not Disturb is switched on, all incoming calls are
rejected and registered as missed calls. The calling side receives a busy signal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Activate [Timeout: Timeout]
where
Timeout : Integer (1..1440)
Set the number of minutes before Do Not Disturb is switched off. If not set, Do Not
Disturb times out after 1440 minutes (24 hours).
xCommand Conference DoNotDisturb Deactivate
Switch off the Do Not Disturb mode. When Do Not Disturb is switched off incoming calls come
through as normal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Deactivate
xCommand Conference SpeakerLock Release
Releases locked speaker set by xCommand Conference SpeakerLock Set. Default voice
switching is switched back on.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Release
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand