Cisco TelePresence SX10 - Gain Access to the Settings; About Settings

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 37
Cisco TelePresence SX10
API Reference Guide
Cameras configuration
xConfiguration Cameras Camera [1] Backlight DefaultMode
This configuration turns backlight compensation on or off. Backlight compensation is useful
when there is much light behind the persons in the room. Without compensation the persons
will easily appear very dark to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Off
USAGE:
xConfiguration Cameras Camera n Backlight DefaultMode: DefaultMode
where
n : Unique ID that identifies the camera. Range: 1..1
Default Mode : Off/On
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
xConfiguration Cameras Camera [1] Brightness Mode
Define the camera brightness mode.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera n Brightness Mode: Mode
where
n : Unique ID that identifies the camera. Range: 1..1
Mode : Auto/Manual
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set
using the Cameras Camera [n] Brightness DefaultLevel setting.
xConfiguration Cameras Camera [1] Brightness DefaultLevel
Define the brightness level. Requires the Cameras Camera [n] Brightness Mode to be set to
Manual.
Requires user role: ADMIN, INTEGRATOR
Default value: 20
USAGE:
xConfiguration Cameras Camera n Brightness DefaultLevel: DefaultLevel
where
n : Unique ID that identifies the camera. Range: 1..1
DefaultLevel : Integer (1..31)
The brightness level.
xConfiguration Cameras Camera [1] Flip
With Flip mode (vertical flip) you can flip the image upside down. Flipping applies both to the
self-view and the video that is transmitted to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: Auto
USAGE:
xConfiguration Cameras Camera n Flip: Flip
where
n : Unique ID that identifies the camera. Range: 1..1
Flip : Auto
Auto: If the camera detects that it is mounted upside down, the image is automatically
flipped.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xConfiguration