Cisco TelePresence SX10 - Xcommand Call Farendcontrol Source Select; Xcommand Call Forward; Xcommand Call Hold; Xcommand Call Ignore

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 93
Cisco TelePresence SX10
API Reference Guide
xCommand Call FarEndControl Source Select
Select which video input source to use as the main source on the far end system.
Requires user role: ADMIN, USER
USAGE:
xCommand Call FarEndControl Source Select [CallId: CallId] SourceId: SourceId
where
CallId : Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
SourceId : Integer (0..15)
Select a video input source on the far end.
xCommand Call Forward
Specifies what number or URI you want to forward your incoming calls to. The display name is a
local reference for the forwarded destination. A message, together with the local reference, is
shown on screen when you have configured the system to forward all calls.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Forward DisplayName: "DisplayName" Number: "Number"
where
DisplayName : String (0, 255)
The local reference for the forwarded destination.
Number : String (0, 255)
The directory number or URI which you want to forward the incoming calls to.
xCommand Call Hold
Put a call on hold.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Hold [CallId: CallId] [Reason: Rea son]
where
CallId : Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
Reason : Conference/Transfer/Other
Internal usage only.
xCommand Call Ignore
Turns off the ringtone for the incoming call. The call can still be answered.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Ignore CallId: CallId
where
CallId : Integer (0..65534)
The CallID is returned when the xCommand Dial command is run. During a call you can
run the xStatus Call command to see the CallId.
xCommand Call Join
Internal usage only.
Requires user role: ADMIN, USER
USAGE:
xCommand Call Join CallId: CallId
where
CallId : Integer (0..65534)
You can have from 1 to 10 CallId parameters in the same command.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand