Cisco TelePresence SX10 - Xcommand Usermanagement Remotesupportuser Getstate; Xcommand Usermanagement User Passphrase Change; Xcommand Usermanagement User Passphrase Set

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 124
Cisco TelePresence SX10
API Reference Guide
xCommand UserManagement RemoteSupportUser GetState
Retrieves the state of the generated remote support user, if one exists.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser GetState
xCommand UserManagement User Passphrase Change
Change the passphrase for the user you logged in as. If you are logged in as the administrator,
this will change the administrator passphrase.
Requires user role: ADMIN, AUDIT, INTEGRATOR, ROOMCONTROL, USER
USAGE:
xCommand UserManagement User Passphrase Change NewPassphrase: "NewPassphrase"
OldPassphrase: "OldPassphrase"
where
NewPassphrase : String (0, 255)
OldPassphrase : String (0, 255)
xCommand UserManagement User Passphrase Set
Set a user passphrase for the specified user. You must be logged in as an administrator to set a
user passphrase.
Requires user role: ADMIN
USAGE:
xCommand UserManagement User Passphrase Set NewPassphrase: "NewPassphrase"
Username: "Username" YourPassphrase: "YourPassphrase"
where
NewPassphrase : String (0, 255)
User name : String (0, 127)
YourPassphrase : String (0, 255)
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand