Cisco TelePresence SX10 - Xconfiguration Conference Defaultcall Rate; Conference Configuration; Xconfiguration Conference Autoanswer Mode; Xconfiguration Conference Autoanswer Mute

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 39
Cisco TelePresence SX10
API Reference Guide
Conference configuration
xConfiguration Conference AutoAnswer Mode
Define the auto answer mode. Use the Conference AutoAnswer Delay setting if you want
the system to wait a number of seconds before answering the call, and use the Conference
AutoAnswer Mute setting if you want your microphone to be muted when the call is answered.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Conference AutoAnswer Mode: Mode
where
Mode : Off/On
Off: You must answer incomming calls manually by pressing the OK key or the green
Call key on the remote control, or by tapping Answer on the Touch controller.
On: The system automatically answers incoming calls, except if you are already in a
call. You must always answer or decline incoming calls manually when you are already
engaged in a call.
xConfiguration Conference AutoAnswer Mute
Define if the microphone shall be muted when an incoming call is automatically answered.
Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration Conference AutoAnswer Mute: Mute
where
Mute : Off/On
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
xConfiguration Conference AutoAnswer Delay
Define how long (in seconds) an incoming call has to wait before it is answered automatically by
the system. Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Default value: 0
USAGE:
xConfiguration Conference AutoAnswer Delay: Delay
where
Delay : Integer (0..50)
The auto answer delay (seconds).
xConfiguration Conference DefaultCall Rate
Define the Default Call Rate to be used when placing calls from the system.
Requires user role: ADMIN, INTEGRATOR
Default value: 3072
USAGE:
xConfiguration Conference DefaultCall Rate: Rate
where
Rate : Integer (64..3072)
The default call rate (kbps).
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xConfiguration