Cisco TelePresence SX10 - Xcommand Conference Speakerlock Set; Diagnostics Commands; Xcommand Diagnostics Run

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 101
Cisco TelePresence SX10
API Reference Guide
xCommand Conference SpeakerLock Set
For manually locking one of the speakers to the prominent speaker position. This overrides the
default voice switching.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Set Target: Target [CallId: CallId]
where
Target : local/remote
Identifies local or remote participant.
CallId : Integer (0..65534)
Identify CallID for the remote participant. Only relevant if Target is set to "remote".
Diagnostics commands
xCommand Diagnostics Run
This command runs self-diagnostics commands on the system.
Requires user role: ADMIN
USAGE:
xCommand Diagnostics Run [ResultSet: ResultSet]
where
ResultSet : Alerts/All/None
You can filter the diagnostics results to alerts, all or none. If not set, the result will show
all results.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand