Cisco TelePresence SX10 - Time Commands; Xcommand Time Datetime Get; Xcommand Time Datetime Set; Userinterface Commands

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 118
Cisco TelePresence SX10
API Reference Guide
Time commands
xCommand Time DateTime Get
Read the time and date from the system.
Requires user role: ADMIN, USER
USAGE:
xCommand Time DateTime Get
xCommand Time DateTime Set
Set the date and time for the system, if not available from NTP (Network Time Protocol).
Requires user role: ADMIN, USER
USAGE:
xCommand Time DateTime Set [Year: Year] [Month: Month] [Day: Day] [Hour: Hour]
[Minute: Minute] [Second: Secon d]
where
Year : Integer (2015..2037)
Month : Integer (1..12)
Day : Integer (1..31)
Hour : Integer (0..23)
Min ut e : Integer (0..59)
Second : Integer (0..59)
UserInterface commands
xCommand UserInterface Extensions Clear
Delete all user interface extensions (widgets) from the video system.
Requires user role: ADMIN
USAGE:
xCommand UserInterface Extensions Clear
xCommand UserInterface Extensions List
List all user interface extensions (widgets) that exist on the video system.
Requires user role: INTEGRATOR, ROOMCONTROL, USER
USAGE:
xCommand UserInterface Extensions List
xCommand UserInterface Extensions Set
Set the configuration scheme you have chosen in the user interface extensions (widgets) for
your room system. Updates the UserInterface Extensions status tree.
Requires user role: ADMIN, INTEGRATOR, ROOMCONTROL
USAGE:
xCommand UserInterface Extensions Set ConfigId: "ConfigId"
where
ConfigId : String (0, 40)
The unique identifier for the configuration.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand