Cisco TelePresence SX10 - Xcommand Callhistory Recents; Camera Commands; Xcommand Camera Positionreset; Xcommand Camera Positionset

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 96
Cisco TelePresence SX10
API Reference Guide
xCommand CallHistory Recents
Retrieve aggregated information on previous calls made on the video system.
Requires user role: ADMIN, USER
USAGE:
xCommand CallHistory Recents [Filter: Filter] [Offset: Offset] [Limit: Limit]
[DetailLevel: DetailLevel] [SearchString: "SearchString"] [CallHistoryId:
CallHistoryId] [Order: Order]
where
Filter : All/Missed/AnsweredElsewhere/Forwarded/Placed/NoAnswer/Received/Rejected/
UnacknowledgedMissed
You can filter which calls to retrieve.
Offset : Integer (0..65534)
Sets the call from which to start.
Limit : Integer (0..65534)
Defines the amount of calls in the output.
DetailLevel : Basic/Full
Sets the level of detail for the information on these calls.
SearchString : String (0, 255)
Allows you to set the command to apply to a specified display name or call back
number.
CallHistoryId : Integer (0..65534)
CallHistoryId for the call in question.
Order : OccurrenceTime/OccurrenceFrequency
Define the order in which the previous calls are presented.
Camera commands
xCommand Camera PositionReset
Reset the camera position to default position.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera PositionReset [Axis: Axis] CameraId: CameraId
where
Axis : All/Focus/PanTilt/Zoom
Select which function to reset. If not specified all are reset.
CameraId : Integer (1..1)
The ID of the camera preset you want to reset.
xCommand Camera PositionSet
Set the camera position.
Requires user role: ADMIN, USER
USAGE:
xCommand Camera PositionSet CameraId: CameraId [Focus: Focus] [Pan: Pan] [Tilt:
T ilt] [Zoom: Zoom]
where
CameraId : Integer (1..1)
The ID of the camera preset you want to reset.
Focus : Integer (0..65535)
Focus the camera near or far.
Pan : Integer (-10000..10000)
Move the camera to the left or right.
T ilt : Integer (-2500..2500)
Move the camera up or down.
Zoom : Integer (0..8500)
Zoom in or out.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand