Cisco TelePresence SX10 - Xconfiguration Userinterface Language; Xconfiguration Userinterface OSD Output; Usermanagement Configuration; Xconfiguration Usermanagement LDAP Mode

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 74
Cisco TelePresence SX10
API Reference Guide
xConfiguration UserInterface Language
Select the language to be used in menus and messages on the screen and Touch controller.
Requires user role: ADMIN, USER
Default value: English
USAGE:
xConfiguration UserInterface Language: Language
where
Language : Arabic/Catalan/ChineseSimplified/ChineseTraditional/Czech/Danish/Dutch/English/
EnglishUK/Finnish/French/FrenchCanadian/German/Hebrew/Hungarian/Italian/Japanese/
Korean/Norwegian/Polish/Portuguese/PortugueseBrazilian/Russian/Spanish/SpanishLatin/
Swedish/Turkish
Select a language from the list. Arabic and Hebrew are not supported in this software
version.
xConfiguration UserInterface OSD Output
Define on which monitor the on-screen menus, information and indicators (OSD) should be
displayed. The system supports only one monitor, so this value is fixed and cannot be changed.
Requires user role: ADMIN, INTEGRATOR
Default value: 1
USAGE:
xConfiguration UserInterface OSD Output: Output
where
Outp ut : 1
UserManagement configuration
xConfiguration UserManagement LDAP Mode
The video system supports the use of an LDAP (Lightweight Directory Access Protocol) server
as a central place to store and validate user names and passwords. Use this setting to config-
ure whether or not to use LDAP authentication. Our implementation is tested for the Microsoft
Active Directory (AD) service.
Requires user role: ADMIN
Default value: Off
USAGE:
xConfiguration UserManagement LDAP Mode: Mode
where
Mode : Off/On
Off: LDAP authentication is not allowed.
On: For client certificate verification to work when LDAP authentication is enabled, the
codec requires a CA (Certificate Authority) certificate, and the user must have a Client
Certificate that matches their user distinguishing name (DN) in the active directory (AD).
xConfiguration UserManagement LDAP Server Address
Set the IP address or hostname of the LDAP server.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration UserManagement LDAP Server Address: "Addre ss"
where
Address : String (0, 255)
A valid IPv4 address, IPv6 address or hostname.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xConfiguration