Cisco TelePresence SX10 - Serialport Configuration; Xconfiguration Serialport Mode; Xconfiguration Serialport Loginrequired; SIP Configuration

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 66
Cisco TelePresence SX10
API Reference Guide
SerialPort configuration
xConfiguration SerialPort Mode
Enable/disable the serial port (connection via Micro USB to USB cable). The serial port uses
115200 bps, 8 data bits, no parity and 1 stop bit.
Requires user role: ADMIN, INTEGRATOR
Default value: On
USAGE:
xConfiguration SerialPort Mode: Mode
where
Mode : Off/On
Off: Disable the serial port.
On: Enable the serial port.
xConfiguration SerialPort LoginRequired
Define if login shall be required when connecting to the serial port.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration SerialPort LoginRequired: LoginRequire d
where
LoginRequired : Off/On
Off: The user can access the codec via the serial port without any login.
On: Login is required when connecting to the codec via the serial port.
SIP configuration
xConfiguration SIP Authentication UserName
This is the user name part of the credentials used to authenticate towards the SIP proxy.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP Authentication UserName: "UserName"
where
UserName : String (0, 128)
A valid username.
xConfiguration SIP Authentication Password
This is the password part of the credentials used to authenticate towards the SIP proxy.
Requires user role: ADMIN
Default value: ""
USAGE:
xConfiguration SIP Authentication Password: "Password"
where
Password : String (0, 128)
A valid password.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xConfiguration