Cisco TelePresence SX10 - Xcommand Audio Sound Play; Xcommand Audio Sound Stop; Xcommand Audio Soundsandalerts Ringtone List; Xcommand Audio Soundsandalerts Ringtone Play

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 88
Cisco TelePresence SX10
API Reference Guide
xCommand Audio Sound Play
Play a specified audio sound.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Audio Sound Play [Loop: Loop] Sound: Sound
where
Loop : Off/On
Determines whether or not to loop the playout of the audio sound. The sound is
looped by default. Irrespective of how this parameter is set, some of the sounds
(Busy, CallWaiting, Dial, Ringing, and SpecialInfo) will play until the Audio Sound Stop
command is issued.
Sound : Alert/Bump/Busy/CallDisconnect/CallInitiate/CallWaiting/Dial/KeyInput/
KeyInputDelete/KeyTone/Nav/NavBack/Notification/OK/PresentationConnect/Ringing/SignIn/
SpecialInfo/TelephoneCall/VideoCall/VolumeAdjust/WakeUp
Choose which ringtone to play.
xCommand Audio Sound Stop
Stop playing audio sound.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Audio Sound Stop
xCommand Audio SoundsAndAlerts Ringtone List
List all available ringtones. Use the xConfiguration Audio SoundsAndAlerts RingTone setting to
choose a ringtone.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Audio SoundsAndAlerts Ringtone List
xCommand Audio SoundsAndAlerts Ringtone Play
Play one of the available ringtones. Use the xCommand Audio SoundsAndAlerts Ringtone List
command to get a list of the available ringtones.
Requires user role: INTEGRATOR, USER
USAGE:
xCommand Audio SoundsAndAlerts Ringtone Play RingTone: "RingTone"
where
RingTone : String (1, 100)
The name of the ringtone.
xCommand Audio Volume Decrease
Decrease the volume on the endpoint. By default, the volume is increased by 5 steps (each
step is 0.5 dB). Use the Steps parameter if you want to override the default behavior.
Requires user role: ADMIN, USER
USAGE:
xCommand Audio Volume Decrease [Steps: Steps]
where
Steps : Integer (1..10)
Choose the number of steps to decrease the volume with. One step is 0.5 dB.
xCommand Audio Volume Increase
Increase the volume on the endpoint. By default, the volume is increased by 5 steps (each step
is 0.5 dB). Use the Steps parameter if you want to override the default behavior.
Requires user role: ADMIN, USER
USAGE:
xCommand Audio Volume Increase [Steps: Steps]
where
Steps : Integer (1..10)
Choose the number of steps to increase the volume with. One step is 0.5 dB.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand