Cisco TelePresence SX10 - Xcommand Roompreset Store; Security Commands; Xcommand Security Persistency; Xcommand Security Session List

D15333.07 Cisco TelePresence SX10 API Reference Guide CE9.1, JUNE 2017. Copyright © 2017 Cisco Systems, Inc. All rights reserved. 113
Cisco TelePresence SX10
API Reference Guide
xCommand RoomPreset Store
Store the connector selections for all video input sources and the current position (pan and tilt),
zoom and focus values for all cameras.
Note that information about all video input sources, and pan, tilt, zoom and focus values for
all cameras are included in the same preset. The system may hold 15 such predefined video
input presets. These presets are available for far end control, i.e. they are referred in the
PresetId parameter of the xCommand FarEndControl Preset Activate command. In contrast, the
xCommand Camera Preset commands applies to individual cameras only. Those presets are
not available for far end control.
Requires user role: ADMIN, USER
USAGE:
xCommand RoomPreset Store [Description: "Description"] PresetId: PresetId Type:
Type
where
Description : String (0, 255)
Enter a description of the camera preset.
PresetId : Integer (1..15)
The ID of this preset.
Type : All/Camera
Not applicable. If you want to ensure that a preset only affects camera positions we
recommend that you select Camera.
Security commands
xCommand Security Persistency
Set the following features to persistent or non-persistent mode. In non-persistent mode
the information gathered by the specified feature does not persist a reboot of the system.
Persistent mode is the default. This command reboots the system.
Requires user role: ADMIN
USAGE:
xCommand Security Persistency Configurations: Configurations CallHistory:
CallHistory InternalLogging: InternalLogging LocalPhonebook: LocalPhonebook
DHCP: DHCP ConfirmAndReboot: ConfirmAndReboot
where
Configurations : NonPersistent/Persistent
In non-persistent mode, all configurations are set back to default when the system
reboots.
CallHistory : NonPersistent/Persistent
In non-persistent mode call history is deleted when the system reboots.
InternalLogging : NonPersistent/Persistent
In non-persistent mode eventlog is deleted when the system reboots.
LocalPhonebook : NonPersistent/Persistent
In non-persistent mode local phone book is deleted when the system reboots.
DHCP : NonPersistent/Persistent
In non-persistent mode all IP related information is deleted when the system reboots.
ConfirmAndReboot : Yes
Reboots the system.
xCommand Security Session List
List active sessions.
Requires user role: ADMIN, USER
USAGE:
xCommand Security Session List
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand