Slide Rail Specifications
• Slide Type: L-shelf
• Install Type: Toolless
• Slide Length: 645 mm
• Working Load: 150 kg
• Supported Rack Range: 645~917 mm
• Supported Chassis Width: 448 mm
• Use Space: 2U*645 mm
• UL Strength Test: Yes
Cisco Slide Rail Kit, which is shipped with the server or with a replacement chassis.
Tools Required for Rack Installation
Following tools are required:
• #2 Phillips Screwdriver
• Lift table. If a lift table is not available, make sure to use at least two people to lift or maneuver the server.
Installing the Server
Before you begin
• Ensure the floor where the rack is placed can support the combined weight of the rack, server, and any
other equipment.
• Have a team of at least two to three people to assist with lifting and positioning the server.
• Clear the area around the rack to ensure there is enough space to work.
• Inspect the rack and server for any damage before starting the installation.
• Consult Installation Warnings and Guidelines, on page 31.
Procedure
Step 1 Locate the Left Front and Right Front rails.
Each rail should have 4 screws.
Cisco UCS C885A M8 Server Installation and Service Guide
34
Installing the Server
Installing the Server
To Next Page
Loading...
