Single-point option
Page 94 CM6200 Operating Manual
To disconnect the feed hoses, press
down on the collar around the hose
and pull the hose out.
4.5.6 Operating the pneumatic feed system
Do the following to operate the pneumatic feed system:
1. Connect the energy sources.
2. Push the START button on
the PCU.
3. To adjust the turntable rota-
tions per minute (RPM), use
the speed adjustment valve
to turn on the drive motor.
4. To adjust the feed rate per
revolution, turn the feed rate
adjustment dial to the minimum feed or to the desired setting, if known.
5. Using the feed on/off valve, turn on the feed and adjust the feed rate for the
desired cut.
Turn the feed on/off valve fully to activate or deactivate the feed rate.
6. Use the speed adjustment valve to adjust the drive motor to achieve the
desired cut.
7. When the cut is complete, first stop the feed and then stop the machine
rotation.
FIGURE 4-47. FEED HOSE DISCONNECT METHOD
TABLE 4-15. PCU VALVES IDENTIFICATION
Number Component
1 Feed on/off valve
2
Speed adjustment
valve
3 Feed rate adjustment
To Next Page