P/N 63674, Rev. 9 Page 11
2 OVERVIEW
IN THIS CHAPTER:
2.1 FEATURES AND OPTIONS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -11
2.1.1 F
EATURES - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -12
2.1.2 A
VAILABLE MACHINE OPTIONS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -12
2.1.3 R
OTARY TABLE SPEEDS USING HYDRAULIC MOTORS WHEN SINGLE-POINT MACHINING - - - - - - - -13
2.2 M
ACHINE COMPONENTS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -14
2.3 M
ACHINE ENVELOPE AND OPERATING DIMENSIONS - - - - - - - - - - - - - - - - - - - - - - - - - - -17
2.4 S
PECIFICATIONS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -19
2.4.1 W
EIGHT SPECIFICATIONS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -19
2.4.2 H
YDRAULIC MOTOR SPECIFICATIONS - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -19
2.1 FEATURES AND OPTIONS
The CM6200 is a highly configurable machine with many options and accessories.
This manual covers the use and operation of some of those possible options. The
machine configuration purchased may not contain all of the options and accesso-
ries detailed herein. If a specific machine application requires additional options or
accessories please contact a CLIMAX sales representative for assistance in obtain-
ing the needed components.
The CM6200 is designed to perform various machining operations on a circular
workpiece, such as a flange. The machine consists primarily of a rotary table with
a precision circular bearing and a servo electric drive. An adjustable machining
arm and counterweight arm are mounted on the table to provide precise machining
in any orientation. A milling head is mounted on a radial slide. The CM6200
mounts to the workpiece by either an ID or OD mount system.
The most common application of the CM6200 is for wind tower connection
flanges. It is used for large diameter flanges with the following dimensions:
• For ID mounting, 78.9–177.2" (2,000– 4,500 mm) inside diameter (see
Figure 2-4 on page 17)
The ID mount machining range is 78.9–197" (2,000– 5,004 mm) with a
8" (203 mm) face mill.
• For OD mounting, 135.5–200.4" (3,442–5,090 mm) outside diameter
(see Figure 2-5 on page 18)
The OD mount machining range is 67.5–197" (1,715– 5,004 mm) with
a 8" (203 mm) face mill.
• For face mounting, 67.5" (1,715 mm) or larger (see Figure 2-5 on page
18)
To Next Page