Columbus Instruments Exer 3/6 - Treadmill Controller; Optional Calibration Wheel; Minimum Computer Specifications; CI-Bus Hub Interface

8
1.1 System Specifications (continued)
1.1.4 Treadmill Controller
Power Requirements: 200 watts, 100, 115, or 230VAC, 50/60Hz (factory selected).
Physical Dimensions: 33.1 x 29.0 x 10.2cm (13.0” x 11.4” x 4.0”).
Physical Weight: 3.2 kilograms (7.0 pounds).
CI-Bus Connection: 8-pin RJ45 Jacks (x2).
Cal. Wheel Connection: 4-pin Amphenol Circular Female Jack.
Motor Connection: 6-pin Amphenol Circular Female Jack.
Shocker Connection: 15-pin Female D-sub.
Belt Speed Range: 0.0 - 102.3 meters/minute.
Acceleration Range: 0.0004 - 25.5 meters/minute/second
Time Limited Range: 0:00:1 to 4:15:59s.
Distance Limited Range: 1.0 to 9,999.0 meters.
1.1.5 Optional Calibration Wheel
Power Requirements: 5VDC @ 100mA.
Physical Dimensions: 20.3 x 4.6 x 4.3cm (8.0” x 1.8” x 1.7”).
Physical Weight: 0.2 kilograms (0.5 pounds).
Connector: 4-pin Amphenol Circular Female Plug.
Wheel Diameter: 4.128cm (1.625”).
Output: 100 pulses per revolution = 0.130cm per pulse.
1.1.6 Minimum Computer Specifications
IBM compatible computer with Windows operating system.
CD-ROM drive for software installation.
20 MB of free hard drive space for software installation.
1.1.7 CI-Bus Hub Interface
Power Requirements: 5VDC (from USB) @ 500mA.
Physical Dimensions: 13.5 x 11.7 x 6.35cm (5.3” x4.6” x 2.5”).
Physical Weight: 0.6 kilograms (1.4 pounds).
Computer Connection: USB 2.0 Type “B” Jack.
CI-Bus Connections: 4 ports (A, B, C & D) x 8p8c (RJ-45) 120ohm terminated.