Columbus Instruments Exer 3/6 - Leveling the Incline Apparatus

20
3.1.0 Leveling the Incline Apparatus (optional)
If the working surface is flat and level, skip this section. Else, the bottom of the apparatus utilizes threaded
feet which can be used raise the corners of the apparatus to level.
Using the 2’ bubble level, determine the highest corner of the apparatus:
 If the highest corner is in the back (the pivot-block end):
 Raise the corresponding front end on the same side to level.
 If the highest corner is in the front (support end):
 Raise the corresponding back end on the same side to level.
 Place the 2’ level across the front of the apparatus and raise the lower front-corner to level.
 Then place the level along the same side and raise the rear corner level.
Recheck all sides to verify the apparatus is level.