38
4.3.2 Accel
When the “TREADMILL BELT” toggle switch is set to “ACCEL”, the treadmill belt is enabled to run and
the speed will begin to accelerate (or decelerate) from the current speed as set by the “SPEED” knob)
toward the end speed, in 0.1meters/minute steps, at the acceleration rate displayed on the screen. The
display will report the current speed of the treadmill belt and the mode indicator will be a staircase that
grows when accelerating or shrinks when decelerating.
4.3.3 Stop
When the “TREADMILL BELT” toggle switch is set to “STOP”, the treadmill belt is disabled from
running and the speed will rapidly decrease to zero. The display will report the speed set by the “SPEED”
knob and the mode indicator will be blank. In “Time Limit” mode, the duration will also freeze to preserve
the remaining time in the session.
To Next Page
Loading...
Need help?
General
