53
SECTION 6
TREADMILL USER MENU
The user menu is used to view and set various parameters which are saved within the Treadmill Controller.
Access to the menu is provided by adjusting the front panel controls to a unique setting (typically not
encountered through normal operation):
If the Treadmill Controller is under computer control (indicated by the speed setting displayed with
“C” instead of “S”), press the “ODOMETER RESET” button to restore control back to the user.
Set the “TREADMILL BELT” toggle switch to “STOP”.
Set the “SPEED” to “88.7” m/min.
Set the “REP RATE” knob to “2Hz”.
Then press the “ODOMETER RESET” button.
The screen will display “User Menu” and leave you at the option for automatic speed and distance
calibration in the menu. Within the menu, the various controls provide the typical functions:
• REP RATE knob: used as an “up/down” selector to navigate the list of menu options.
Move up: select: “3Hz” and then back to “2Hz”.
Move down: select: “1Hz” and then back to “2Hz”.
• ODOMETER RESET: used to select the current menu option. When editing, a simple
press-and-release will cancel the edit and restore the previous value.
You must press-and-hold to save the new setting as current.
• SPEED knob: used to select a value from a range of values.
• TREADMILL BELT toggle: used to begin, cancel, and complete the auto-calibration procedure.
To Next Page
Loading...
Need help?
General
