60
6.8.2 Distance Limited
This mode limits the distance travelled in the exercise session. This is indicated by the label “L” for the
measured odometer distance which counts down as the treadmill belt moves. When the odometer reaches
zero (0.0), the belt will stop. At any time, pressing the “ODOMETER RESET” button will reload the
odometer with the distance limit and the treadmill belt will act according to the “TREADMILL BELT”
setting.
Press the “ODOMETER RESET” button to select the option. The displayed mode is now editable.
Use the “SPEED” knob to select “Distance Limit”.
Then press-and-hold the “ODOMETER RESET” button to save. Now the 1,000 & 100 digits of the
odometer are editable.
Use the “SPEED” knob to select the distance from 0 to 9,900 meters.
Then press-and-hold the “ODOMETER RESET” button to save. Else press-and-release to cancel.
Now the 10 & 1 digits of the odometer are editable.
Use the “SPEED” knob to select the distance from 0 to 99 meters.
Then press-and-hold the “ODOMETER RESET” button to save. Else press-and-release to cancel.
6.9 Exit
This option is used to exit the menu.
Press the “ODOMETER RESET” button to select the option. The display will show the current
settings of the treadmill and the controls will revert back to typical operation.
To Next Page
Loading...
Need help?
General
