59
6.8.1 Time Limited
This mode limits the time duration of the exercise session. This is indicated when the odometer is replaced
by a count-down timer: “T”. The timer will count-down at any belt speed when the “TREADMILL BELT”
toggle is set to “RUN” or “ACCEL”. The timer will freeze when “TREADMILL BELT” toggle is set to
“STOP” (and the belt speed will also stop) preserving the remaining time duration. When the timer reaches
zero (0:00), the belt will stop. At any time, pressing the “ODOMETER RESET” button will reload the
timer with the time limit and the treadmill belt will act according to the “TREADMILL BELT” setting.
Press the “ODOMETER RESET” button to select the option. The displayed mode is now editable.
Use the “SPEED” knob to select “Time Limit”.
Then press-and-hold the “ODOMETER RESET” button to save. Now the minutes of the time limit are
editable.
Use the “SPEED” knob to select the number of minutes from 0 to 255 (up to 4 hours and 15 minutes).
Then press-and-hold the “ODOMETER RESET” button to save. Else press-and-release to cancel.
Now the seconds of the time limit are editable.
Use the “SPEED” knob to select the number of seconds from 0 to 59.
Then press-and-hold the “ODOMETER RESET” button to save. Else press-and-release to cancel.
To Next Page
Loading...
Need help?
General
