57
6.7 Acceleration Settings
This option is used to set the acceleration rate and ending speed of the treadmill belt when the
“TREADMILL BELT” toggle is set to “ACCEL”. The screen displays three adjustable settings:
• Acceleration Step: 0.0 to 25.5 meters/minute (m/min).
• Acceleration Interval: 0 to 255 seconds (s).
• Ending Speed: 0.0 to 102.3 meters/minute (m/min).
The Ending Speed (E:), previously known as Maximum Speed, is the target speed to accelerate (or
decelerate) towards and maintain once achieved. The acceleration rate (A:) is determined by dividing the
Acceleration Step by the Acceleration Interval. Should any of the acceleration arguments be zero, then the
acceleration is “OFF” and the default acceleration rate of 100.0 meters/minute/second is employed.
Press the “ODOMETER RESET” button to select the option. The displayed Acceleration Step is now
editable.
Use the “SPEED” knob to select the new value for the Acceleration Step.
Then press-and-hold the “ODOMETER RESET” button to save the new setting. Else, press-and-
release to cancel. Now the Acceleration Interval is editable.
Use the “SPEED” knob to select the new value for the Acceleration Interval.
Then press-and-hold the “ODOMETER RESET” button to save the new setting. Else, press-and-
release to cancel. Now the Ending Speed is editable.
Use the “SPEED” knob to select the new value for the Ending Speed.
Then press-and-hold the “ODOMETER RESET” button to save the new setting. Else, press-and-
release to cancel. Now the currently saved acceleration settings are displayed.
To Next Page
Loading...
Need help?
General
