15
3.0 Typical Item Inventory (continued)
You may also need the following tools for assembling the system:
• Phillips (cross-point) screwdriver, medium tip.
• Common (flat-point) screwdriver, small tip.
• 5/16-inch (7.5mm) wrench.
The Treadmill system is easy to assemble provided that the components of the system are placed correctly.
A working surface that averages 1.3m x 1.0 m (6-foot x 3-foot, width x depth) with access to the front and
back is recommended. It will facilitate adjustments to the inclination rod as well as loading and unloading
the animals.
When possible, it is recommended to use an AC power strip to provide a common access to AC power for
all components of the Treadmill system and the host computer. Most AC power strips incorporate a master
switch that can switch on and off the AC power to the entire system and protect against electrostatic
discharge. It also provides a beneficial common ground between all components to help prevent
unintentional ground loops which may exists between the individual AC power outlets of a room.
To Next Page
Loading...
Need help?
General
