Compaq Deskpro 2000 - Bezel Blank

Compaq Deskpro 2000 Series of Personal Computers 6-27
6.16.3 Bezel Blank
To remove a bezel blank, complete the following steps:
1. Remove the access panel (Section 6.6.1).
2. Remove the front bezel (Section 6.16.1).
3. Lay the front bezel face down on a protected work surface and remove the two screws that secure
the bezel blank to the front bezel.
4. Remove the bezel blank from the front bezel.
Figure 6-27.
Removing the Bezel Blank
To reinstall the bezel blank, reverse the above procedure.