B-2 Power Cord Set Requirements
Country-Specific Requirements
Power Cord Set Requirements–By Country
Country Accrediting Agency Applicable Note Numbers
Australia EANSW 1
Austria OVE 1
Belgium CEBC 1
Canada CSA 2
Denmark DEMKO 1
Finland SETI 1
France UTE 1
Germany VDE 1
Italy IMQ 1
Japan JIS 3
Norway NEMKO 1
Sweden SEMKO 1
Switzerland SEV 1
United Kingdom BSI 1
United States UL 2
✎
The flexible cord must be <HAR> Type HO5VV-F, 3-conductor, 1.0 mm
2
conductor
size. Power cord set fittings (appliance coupler and wall plug) must bear the certification
mark of the agency responsible for evaluation in the country where it will be used.
The flexible cord must be Type SJT or equivalent, No. 18 AWG, 3-conductor. The wall
plug must be a two-pole grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-
15P (15A 250V) configuration.
The appliance coupler, flexible cord, and wall plug must bear a "T" mark and
registration number in accordance with the Japanese Dentori Law. The flexible cord
must be Type VCT or VCTF, 3-conductor, 0.75 mm
2
conductor size. The wall plug
must be a two-pole grounding type with a Japanese Industrial Standard C8303 (15A,
125V) configuration.
To Next Page
Loading...
