Compaq Deskpro 2000 - Hard Drive Test Error Codes

Compaq Deskpro 2000 Series of Personal Computers E-5
Table E-9
Hard Drive Test Error Codes
Error
Code Description Recommended Action
1701-xx Hard drive format test failed. The following steps apply to error codes 1701-xx through 1736-xx:
1702-xx Hard drive read test failed.
1. Run Computer Setup and verify drive type.
1703-xx Hard drive write/read/compare test failed.
2. Replace the hard drive signal and power cables and retest.
1704-xx Hard drive random seek test failed.
3. Replace the hard drive and retest.
1705-xx Hard drive controller test failed.
4. Replace the system board and retest.
1708-xx Hard drive format bad track test failed.
1710-xx Hard drive park head test failed.
1715-xx Hard drive head select test failed.
1716-xx Hard drive conditional format test failed.
1717-xx Hard drive ECC* test failed.
1719-xx Hard drive power mode test failed.
1724-xx Hard drive network preparation test failed.
1736-xx Hard drive monitoring test failed.
*Error Correction Code.
Table E-10
Tape Drive Test Error Codes
Error
Code Description Recommended Action
1900-xx Tape drive ID test failed. The following steps apply to error codes 1900-xx through 1910-xx:
1901-xx Tape drive servo test failed.
1. Replace the tape cartridge and retest.
1902-xx Tape drive format or format verification test
failed.
2. Check and/or replace the signal cable and retest.
1903-xx Tape drive sensor test failed.
3. Check the switch settings on the adapter board (if applicable).
1904-xx Tape drive BOT/EOT test failed.
4. Replace the tape adapter board (if applicable) and retest.
1905-xx Tape drive read test failed.
5. Replace the tape drive and retest.
1906-xx Tape drive write/read/compare failed.
6. Replace the system board and retest.
1910-xx Tape erase test failed.