E-10 Diagnostic Error Codes
Table E-18
SCSI Test Error Codes
Error Code Description Recommended Action
XXXX-02 Drive not installed. Check cable connections.
XXXX-03 Media not in drive. Check for and install DATA CD or write-enabled tape in drive.
XXXX-05 Seek failure. Replace the indicated device.
XXXX-06 Drive timed out. Replace the indicated device.
XXXX-07 Drive busy. Replace the indicated device.
XXXX-08 Drive already reserved. Replace the indicated device.
XXXX-09 Unknown.
XXXX-10 Unknown.
XXXX-11 Media soft error. Replace the indicated device.
XXXX-12 Drive not ready. Replace the indicated device.
XXXX-13 Media error. Replace the indicated device.
XXXX-14 Drive hardware error. Replace the indicated device.
XXXX-15 Illegal drive command. Replace the indicated device.
XXXX-16 Media was changed. Replace the indicated device.
XXXX-17 Tape write-protected.
1. Disable write-protect on tape cartridge.
2. Replace tape drive.
XXXX-18 No data detected. Replace the indicated device.
XXXX-21 Drive command aborted. Replace the indicated device.
65XX-24 Media hard error.
1. Back up data and perform Surface Analysis to reallocate defect.
2. Replace drive.
66XX-24 Media hard error.
1. Replace current DATA CD with different DATA CD.
2. Replace drive.
67XX-24 Media hard error.
1. Ensure correct media type for this tape drive.
2. Replace current tape with new tape.
3. Replace tape drive.
XXXX-25 Unknown.
XXXX-30 Controller timed out. Replace the indicated device.
XXXX-31 Unrecoverable error. Replace the indicated device.
XXXX-32 Controller/drive disconnected. Replace the indicated device.
XXXX-33 Illegal controller command. Replace the indicated device.
XXXX-34 Invalid SCSI bus phase. Replace the indicated device.
XXXX-35 Invalid SCSI bus phase. Replace the indicated device.
XXXX-36 Invalid SCSI bus phase. Replace the indicated device.
XXXX-39 Error status from drive. Replace the indicated device.
XXXX-40 Target timed out. Replace the indicated device.
Continued
To Next Page
Loading...
