test failed and retest.
102 - 11 Numeric coprocessor
speed test failed
102 - 12 Numeric coprocessor
pattern test failed
102 - 14 Switch indicates no
coprocessor present
102 - 15 Coprocessor is inoperative
or socket is unoccupied
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
103 - 01 Direct memory access page Replace the system board and
registers test failed retest for error codes 103 - 01
through 113 - 01.
103 - 02 Direct memory access byte
controller test failed
103 - 03 Direct memory access word
controller test failed.
104 - 01 Interrupt controller master
test failed.
104 - 02 Interrupt controller slave
test failed.
104 - 03 Interrupt controller
software RTC is inoperative.
105 - 01 Port 61, bit 6 not at zero.
105 - 02 Port 61, bit 5 not at zero.
105 - 03 Port 61, bit 3 not at zero.
105 - 04 Port 61, bit 1 not at zero.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
105 - 05 Port 61, bit 0 not at zero. Replace the system board
and retest for error codes
105 - 06 Port 61, bit 5 not at one. 103 - 01 through 113 - 01.
105 - 07 Port 61, bit 3 not at one.
105 - 08 Port 61, bit 1 not at one.
105 - 09 Port 61, bit 0 not at one.
105 - 10 Port 61 I/O test failed.
105 - 11 Port 61, bit 7 not at zero.
To Next Page
Loading...
Need help?
General