EasyManua.ls Logo

Compaq PORTABLE 386 - Tape Drive Error Codes (19 Xx - XX Range)

Compaq PORTABLE 386
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1717 - xx Fixed Disk Drive ECC Test
1717 - 01 Exceeded maximum soft error
limit.
1717 - 02 Exceeded maximum hard error
limit.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1717 - 03 Previously exceeded maximum The following steps apply to error
soft error limit. codes 1700 - xx through 1717 - 73:
1717 - 04 Previously exceeded maximum 1. Check the system board jumper
hard error limit. settings and retest
(see Chapter 9, "Jumper and
1717 - 05 Reset controller failed. Switch Settings").
2. Replace the fixed disk drive
1717 - 06 Fatal error while reading signal and power cables and
(BIOS st.>=0x20). retest.
3. Replace the fixed disk drive
1717 - 07 Fatal error while writing. and retest.
4. Replace the system board and
1717 - 08 Failed compare of write/read retest.
buffers.
1717 - 40 Cylinder 0 failed.
1717 - 55 Cylinder 1 error.
1717 - 61 Failed uncorrectable error.
1717 - 62 Failed correctable error.
1717 - 65 Exceeded maximum bad sector
per track.
1717 - 67 Failed to write long.
1717 - 68 Failed to read long.
1717 - 70 Failed translate mode.
1717 - 71 Failed nontranslate mode.
1717 - 72 Exceeded maximum bad track
limit.
1717 - 73 Previously exceeded maximum
bad track limit.
==============================================================================
Table 6-12. Tape Drive Error Codes (19xx - xx Range)
==============================================================================

Table of Contents

Related product manuals