1906 - 06 Tape write protected error. The following codes apply to
error codes 1900 - xx through
1906 - 14 Drive timeout error. 1991 - xx:
1906 - 16 Block locate (block ID) error. 1. Replace the tape cartridge
and retest.
1906 - 17 Soft error limit exceeded. 2. Replace the tape drive
expansion unit and retest.
1906 - 18 Hard error limit exceeded. 3. Replace the system board
and retest.
1906 - 19 Write (probably ID error).
1906 - 20 765 Fatal error.
1906 - 24 Fail write protect test.
1906 - 26 Cannot ID drive.
1906 - 27 Drive not compatible with
controller.
1991 - 12 Tape has not been servo
written.
==============================================================================
Table 6-13. COMPAQ Video Graphics Error Codes (24xx - xx Range)
==============================================================================
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
2402 - 01 Video Memory Test The following steps apply to error
codes 2402 - 01 through 2416 - 01:
2403 - 01 Video Attribute Test
1. Verify switch settings on the
2401 - 01 Video Character Set Test video board and system board.
2. Replace the video board and
2405 - 01 Video 80 x 25 Mode9x14 retest.
Character Cell Test 3. Replace the system board and
retest.
2406 - 01 Video 80 x 25 Mode8x8
Character Cell Test
2407 - 01 Video 40 x 25 Mode Test
2408 - 01 Video 320 x 200 Mode Color
Set 0 Test
2409 - 01 Video 320 x 200 Mode Color
Set 1 Test
2410 - 01 Video 640 x 200 Mode Test
2411 - 01 Video Screen Memory Page Test
2412 - 01 Video Gray Scale Test
To Next Page
Loading...
Need help?
General