COMP21.BAT Batch file to run patch
COMP21.DOC Documentation for patch
PATCH.EXE Main patch program
8. If you applied any patches, place the patched files on the working copies
of the appropriate NetWare diskettes. Use the NETGEN program to generate
and link the NetWare operating system and utilities.
9. Run COMPSURF to perform a surface analysis on the server fixed disk
drives. Following are appropriate responses to COMPSURF prompts:
Format the disk? N
Retain the bad block list? N
Enter bad blocks? N
Number of sequential passes At least 1 (one) pass
Random I/O operations Take the default number
10. Use the "NetWare Installation" option from the NETGEN Main Menu to
install NetWare. It may be necessary to apply an additional patch to the
COMPSURF.OBJ file. The following files should also appear in the root
directory of the EXTDISK diskette:
HCDCMPSF.BAT
HCDCMPSF.DOC
NOTE: When installing NetWare on high capacity fixed disk drives, the NETGEN
program may halt and display the following message:
ABEND : Not enough memory for disk FAT tables.
There are two methods of installing software if this occurs:
1) by limiting the SYS: volume size to less than 200 megabytes when running
the installation program to avoid the memory error, or
2) by avoiding the "NetWare Installation" choice on the NETGEN Main Menu and
installing the software manually.
To install the software manually, follow these procedures:
From the A> prompt, enter the following commands:
A> INSTOVL 1 x Where x is SUPPORT for 5 1/4 inch diskettes
NETGEN for 3 1/2 inch diskettes
A> NINSTALL -ox -pr Where x is
1 - Advanced NetWare
2 - SFT NetWare
3 - SFT NetWare with TTS
A> INSTOVL 2 x Where x is SUPPORT
for 5 1/4 inch diskettes
NETGEN for 3 1/2 inch diskettes
To Previous Page
Loading...
Need help?
General