1. Replace the plasma display
5103 - 01 Video Attribute Test controller board and retest.
2. Replace the plasma display
5104 - 01 Video Character Set Test and retest.
3. Replace the system board
5105 - 01 Video 80 x 25 Mode9x14 andretest.
Character Cell Test
5106 - 01 Video 80 x 25 Mode8x8
Character Cell Test
5107 - 01 Video 40 x 25 Mode Test
5108 - 01 Video 320 x 200 Mode Color
Set 0 Test
5109 - 01 Video 320 x 200 Mode Color
Set 1 Test
5110 - 01 Video 640 x 200 Mode Test
5111 - 01 Video Screen Memory Page Test
5112 - 01 Video Gray Scale Test
5114 - 01 Video White Screen Test
5116 - 01 Video Noise Pattern Test
5124 - 01 Monochrome Test
5129 - 01 Video 640 x 400 Mode Test
==============================================================================
Chapter 6.4 Memory Error Codes
Memory error codes result when the system detects a memory fault during the
Power On Self Test or as a result of a DIAGNOSTIC test. The TEST programs
attempt to isolate the memory fault to a specific chip, then generate a memory
error code that identifies the system board, memory board, or the defective
memory module to replace.
In some cases, replacing the memory module will not solve the problem because:
o The system may not be able to accurately determine which module is at fault
if multiple memory errors are detected.
o The problem may be due to a failure in the memory support circuitry, not
the memory.
The memory error code points to a specific memory address. The physical
location of the memory address depends on the memory expansion board or memory
module used.