Compaq PORTABLE 386 User Manual

To replace the mass storage device subassembly, reverse steps 7 and 8.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
When replacing the mass storage device subassembly, be sure that the cables do
not interfere with the mass storage device enclosure.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Reconnect the cables, listed in step 5, to the system board.
To replace the bezel and rear panel, reverse steps 1 through 4.
Chapter 8.17 Fixed Disk Drive
To remove the fixed disk drive assembly:
1. Complete the preparation procedure (see Section 8.2).
2. Remove the rear panel (see Section 8.4).
3. Remove the mass storage device subassembly (see Section 8.12).
4. Locate the fixed disk drive (Figure 8-43) mounted in the rear position of
the mass storage device subassembly (Drive Position 2).
5. Disconnect the fixed disk drive power and data cables from the fixed disk
drive (Figure 8-44).

Compaq PORTABLE 386 Specifications

General

Brand	Compaq
Model	PORTABLE 386
Category	Desktop
Language	English