605 - xx Diskette ID Media Test The following steps apply to error
codes 600 - xx through 699 - 00:
605 - 20 Failed to get drive type
1. Replace the diskette and retest.
605 - 24 Failed to read diskette 2. Check the jumper settings on
media the system board and retest
(see Chapter 9, "Jumper and
605 - 25 Failed to verify diskette Switch Settings").
media 3. Check the diskette power and
signal cables.
606 - xx Diskette Speed Test 4. Replace the diskette power and
signal cables and retest.
606 - 26 Failed to read media in 5. Replace the diskette drive and
speed test retest.
6. Replace the system board and
606 - 26 Failed speed limits retest.
607 - xx Diskette Wrap Test
607 - 10 Failed sector wrap test
608 - xx Diskette Write Protect Test
608 - 28 Failed Write Protect Test
609 - xx Diskette Reset Controller Test
609 - 05 Failed to Reset Controller
610 - xx Diskette Change Line Test
610 - 21 Failed to get change line
status
610 - 22 Failed to clear change line
status
697 - 00 Diskette type error.
698 - 00 Diskette drive speed not
within limits
699 - 00 Drive/media ID error;
rerun SETUP
==============================================================================
Table 6-8. Monochrome Video Board Error Codes (8xx - xx Range)
==============================================================================
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
802 - 01 Video memory test failed. 1. Replace monitor and retest.
2. Replace monochrome board and
824 - 01 Monochrome text mode test retest.
failed. 3. Replace system board and retest.
==============================================================================
Table 6-9. Serial Communications Error Codes (11xx - xx Range)
==============================================================================
Error