WARNING
This computer contains a lithium battery that may explode if mistreated. Do
not abuse, disassemble, or dispose of in fire.
Use only replacement batteries supplied by Compaq Computer Corporation
(PN 107786-001)
Disposal of the lithium battery should be accomplished within compliance of
local regulations or returned to Compaq Computer Corporation by established
parts return methods.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To remove the battery:
1. Complete the preparation procedure (see Section 8.2).
2. Remove the rear panel (see Section 8.4).
3. Remove the interface connector cover, if installed (see Section 8.5).
4. Remove the 32 bit memory/modem interface board, if installed (see
Section 8.8).
5. Remove the system board assembly (see Section 8.14).
6. Locate the battery shown in Figure 8-98.
7. Remove the battery as shown in Figure 8-99.
To Next Page
Loading...
Need help?
General