112 - 08 Speed test unable to enter
auto mode.
112 - 09 Speed test unable to enter
high mode.
112 - 10 Speed test high mode out
of range.
112 - 11 Speed test auto mode out
of range.
112 - 12 Speed test variable speed
mode inoperative.
113 - 01 Protected mode test failed.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
114 - 01 Speaker test failed. 1. Verify that speaker is
connected.
2. Replace the speaker and retest.
3. Replace the system board and
retest.
------------------------------------------------------------------------------
199 - 00 Installed devices test 1. Check system configuration.
failed. 2. Verify cable connections.
3. Check switch settings.
4. Run SETUP.
5. Replace system board and retest.
==============================================================================
Table 6-3. Memory Error Codes (2xx - xx Range)
==============================================================================
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
201 - 01 Memory machine ID The following steps apply to error
test failed. codes 201 - 01 through 202 - 03:
202 - 01 Memory system ROM 1. Replace plasma display
checksum failed. controller board.
2. Replace the system ROM and
202 - 02 RAM/ROM system test failed. retest.
3. Replace the system board and
202 - 03 RAM/ROM protect test failed. retest.
------------------------------------------------------------------------------
203 - 01 Memory write/read test failed Replace the appropriate memory
test failed. module(s) or memory board and
retest for error codes 203 - 01
203 - 02 Error during saving program through 210 - 03. Refer to
memory in write/read test. Section 6.4.
203 - 03 Error during restore of
program in write/read test
204 - 01 Memory address test failed
To Next Page
Loading...
