the system board and retest
601 - xx Format Test (see Chapter 9, "Jumper and
Switch Settings").
601 - 05 Failed to reset controller 3. Check the diskette power and
signal cable.
601 - 09 Failed to format a track 4. Replace the diskette power and
signal cables and retest.
601 - 23 Failed to set drive type in 5. Replace the diskette drive and
ID media retest.
6. Replace the system board and
602 - xx Diskette Read Test retest.
602 - 01 Exceeded maximum soft error
limit
602 - 02 Exceeded maximum hard error
limit
602 - 03 Previously exceeded maximum
soft error limit
602 - 04 Previously exceeded maximum
hard error limit
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
602 - 05 Failed to reset controller The following steps apply to error
codes 600 - xx through 699 - 00:
602 - 06 Fatal error while reading
1. Replace the diskette and retest.
603 - xx Diskette Write/Read/Compare 2. Check the jumper settings on
Test the system board and retest
(see Chapter 9, "Jumper and
603 - 07 Fatal error while writing Switch Settings").
3. Check the diskette power and
603 - 08 Failed compare of write/read signal cables.
buffers 4. Replace the diskette power and
signal cables and retest.
604 - xx Diskette Random Seek Test 5. Replace the diskette drive and
retest.
604 - 01 Exceeded maximum soft error 6. Replace the system board and
limit retest.
604 - 02 Exceeded maximum hard error
limit
604 - 03 Previously exceeded soft
error limit
604 - 04 Previously exceeded hard
error limit
604 - 05 Failed to reset controller
604 - 06 Fatal error while reading
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
To Next Page
Loading...
Need help?
General