Transport, packaging and storage
34 D111XXXXXX | 05 2023-05
4 Transport, packaging and storage
4.1 Transport Inspection
Depending on the type and product scope of the charging system, it is delivered either upright or
horizontally in appropriate transport and protective packaging. Depending on the type of charging
system, air-cushioned protective films and/or cardboard boxes are used. The materials can also be
used as underlay during subsequent assembly.
1. After unpacking, thoroughly inspect the charging system for transport damage.
2. Compare the serial number of the charging system with that of the delivery documents to
exclude faulty deliveries.
3. Check delivery according to purchase and scope of delivery for completeness.
4. Proceed as follows in case of deviations or recognisable damages:
– Do not accept delivery or only accept it conditionally.
– Complaints must be reported immediately to the manufacturer in writing.
We recommend to keep and reuse the original packaging for further transportation. Otherwise, the
packaging material must be disposed of in accordance with the applicable local regulations.
4.2 Storage conditions
The system should be stored in the same position that it was transported in. If this is not possible for
undetermined reasons, it should be stored in the installation position of the charging system.
• Ambient temperature for storage: -25 °C to +50 °C
• Permissible relative humidity: maximum 95 % (non-condensing)
• For intermediate storage, store the charging system in the original packaging
To Next Page