Installation
2023-05 D111XXXXXX | 05 39
Installationsarbeite n
5.3 Installation work
The assembly and installation work requires specific technical qualifications and expertise. There is a
danger to life for persons who carry out work for which they have neither been qualified nor
instructed. The work may only be carried out by persons who are familiar with it, have been informed
about dangers and have the necessary qualifications.
Observe the national legal requirements and regulations during assembly and installation.
5.4 Mechanical installation
Incorrect installation and start-up
Improper performance of work can lead to serious injuries and damage to property.
• Work may only be carried out by trained specialist personnel.
• Meet all safety requirements before installation.
• Only carry out mechanical installation in a de-energized state.
• Provide sufficient free space for the installation. The installation site must be sufficiently
accessible so that the charging system can be installed and serviced without interference.
• Use a suitable lifting tool with sufficient load capacity during installation.
The use of specific installation materials for the charging system may be necessary depending on the
condition of the ground or special local conditions. The necessity must be considered individually at
each location.
The following description of installation with specific installation material is exemplary. Local
conditions are not dealt with in detail. Deviating procedures may only be initiated by competent
persons.
To Next Page